Balltec Engineered Solutions
Search
Close this search box.

LiftLOK-2500-QCT

LiftLOK, 2500 mT, Quick Connect Lifting Tool (QCT)

A custom designed LiftLOK 2500 mT WLL ball & groove connector, the LiftLOK-2500-QCT is designed to provide a rapid connection between a 2500 mT shackle and bespoke interface.

LiftLOK, ballgrab, ball and groove, 2500 mT, high load, Quick connect and disconnect tool, remote connector

Weight

5350 kg

WLL

2500 mT dynamic load

Connection

2500 mT WLL GN H14 Wide Body Shackle

Contingency

Full hydraulic and data redundancy

Monitoring

LVDT monitoring system and nose camera

Operation

Hydraulic and data umbilical

LiftLOK, ballgrab, ball and groove, 2500 mT, high load, Quick release disconnect, remote connector, interface, key components
tension relief
ROV grab bar
data connection
ROV interface
HS interface
load balls

The LiftLOK Quick Connection Lifting Tool (QCT) provides an easy to use and safer alternative to traditional shackle methods.

The QCT can be remotely guided into the receptacle using the nose-mounted camera and the connection status verified using the linear transducer monitoring system. This information is then transmitted, latency free, to the vessel control room.

Using the ‘ball & groove’ method the tool mechanically locks to the receptacle.

The QCT can then be remotely disconnected again. In case of issues with with vessel equipment, the QCT can also be hydraulically disconnected via the ROV interface.

LiftLOK, ballgrab, ball and groove, 2500 mT, high load, Quick release disconnect, remote connector male

Male connector

LiftLOK, ballgrab, ball and groove, 2500 mT, high load, Quick release disconnect, remote connector receptacle

Receptacle interface

LiftLOK, ballgrab, ball and groove, 2500 mT, high load, Quick release disconnect, remote connector with GN H14 Wide Body Shackle

2500 mT WLL GN H14 Wide Body Shackle

Latest Project Application

CSBC-DEME Hai Long Offshore Wind Farm

A client requested a custom designed LiftLOK, 2500 mT Quick Connection Lifting Tool (QCT) which could interface between a 2500 mT WLL shackle and a pre-piling template fitted with metrology and hydraulic systems.

The pre-piling template is be used to guide the installation of pin piles for jacket foundations using CAPE’s VLT-640 Single pile driver.

The LiftLOK was chosen by the client because of its safer rapid remote controlled operation that could save potentially hundreds of hours compared to a regular shackle.

 

Contact us

Fill in your details below along with a brief message about your requirements and someone will get back to you within 24 hours.

Application form

Fill in the following details and click the Submit button.

You will hear from us within three working days.